Adjusting the level
Load the file
Choose a recording up to 300 MB. The page reads its current peak level in dBFS.
Pick a mode
Make louder or quieter gives a slider from -30 to +30 dB, with the percentage of the original level beside it. Normalise to -1 dB peak works out the gain for you.
Read the three figures
Current peak, Gain applied and New peak show exactly what will happen. If the boost would take the peak above about -0.9 dBFS, the limiter rounds it off, and New peak shows the softened level the file will really have, never more than 0 dBFS.
Save
Choose MP3 or WAV and press Apply and save, then play and download the version with -volume in its name.
Example: a quiet client testimonial
A testimonial recorded on a laptop microphone peaks at only -9.3 dBFS, so it sounds timid next to the rest of a case study video. Normalising brings the peak up to -1.0 dBFS by applying +8.3 dB of gain, and nothing is limited because the new peak stays below full scale.
Current peak: -9.3 dBFS Mode: Normalise to -1 dB peak
Gain applied: +8.3 dB New peak: -1.0 dBFS
The terms on the page
- dBFS
- Decibels relative to full scale. 0 dBFS is the loudest level a digital file can hold; everything real is below it, so peaks are negative numbers.
- Gain
- How much the level is raised or lowered. +6 dB roughly doubles the signal (the page shows 200%), and -6 dB halves it.
- Normalise
- Turning the whole file up or down by one fixed amount so that its single loudest sample reaches a target, here -1 dBFS.
- Limiting
- When a boost would push samples past full scale, they are gently rounded off near the top instead of being cut flat, which avoids harsh crackles.
Questions people ask
Why does my file still sound quiet after normalising?
Normalising looks only at the single loudest peak. If one cough or knock is much louder than the speech, that peak limits how far the rest can be raised. Trim away the loud moment first, or use a manual boost and accept a little limiting on that one sound.
How much louder is +10 dB?
In signal terms +10 dB is a little over three times the level, which the slider shows as 316%. Our ears judge +10 dB as roughly twice as loud. Small changes of 2 or 3 dB are often enough to match one clip to another.
Will boosting the volume add noise?
It raises everything equally, including background hum, hiss and room noise. The ratio between voice and noise stays the same, but quiet noise can become noticeable. This tool does not remove noise, so record close to the microphone where possible.
Where your data goes
Peak measurement and gain are calculated in your browser on the decoded samples. The audio itself is not transmitted to anyone.
Checked against the tool on