Map Extract
Free tool

MP3 compressor

Load an MP3 or other audio file, then either choose a bitrate or type a target size in megabytes. The expected size is shown before you compress.

Runs in your browser. Nothing you enter is uploaded.

Example: getting a recording under 5 MB

A consultant wants to send a ten-minute recorded briefing, a stereo MP3 at 128 kbps of about 9.2 MB, to a client whose system rejects anything over 5 MB. In Aiming for a file size mode they type 5.

The tool picks the highest bitrate that fits, 64 kbps, lowers the sample rate automatically to 32 kHz to suit it, and predicts about 4.58 MB, half the original size. Ticking Mono keeps the same bitrate but lets the sample rate stay at 44.1 kHz, which often sounds better for a single speaker.

Input
briefing.mp3, 10:00.0, stereo, 44.1 kHz
Aiming for a file size: 5 MB
Result
64 kbps constant bitrate, stereo, 32 kHz
Expected size about 4.58 MB (50% smaller than now)

Compressing an MP3

  1. Load the audio

    Choose an MP3, or a WAV, M4A, OGG or FLAC file. The page shows its length, channels, sample rate and current size.

  2. Choose how to compress

    Choosing a bitrate offers 32 to 192 kbps; the low end is marked for speech. Aiming for a file size asks for the largest size in MB and works out the bitrate.

  3. Fine-tune

    Leave Sample rate on Automatic, or set 44.1, 32, 22.05 or 16 kHz yourself. Tick Mono for a single voice.

  4. Compress and compare

    Press Compress. The result shows the new size and the percentage change, with a player and a download button.

Why the size is predictable

The output is constant bitrate, so the size is simply bitrate multiplied by length: 64 kilobits a second for 600 seconds is 4.8 million bytes, plus a small allowance for headers. That is why the tool can promise a figure before it encodes, and why the only real ways to make a file smaller are a lower bitrate or a shorter recording.

If the original already uses the bitrate you choose or a lower one, the new file will not shrink, and the page says so.

Questions people ask

What bitrate is good enough for speech?

For one person talking, 48 to 64 kbps in mono is usually perfectly clear, and 32 kbps is still understandable for long recordings. Conversations with several voices or background music benefit from 96 kbps or more. Listen to the result in the page's player before you send it.

What does the automatic sample rate do?

Low bitrates cannot carry full-range audio well, so the tool lowers the sample rate to match: below about 112 kbps in stereo it uses 32 kHz, and lower still it drops to 22.05 or 16 kHz. In mono the thresholds are lower, so the full 44.1 kHz is kept down to 64 kbps.

Why can't my target size be reached?

Every bitrate has a minimum size for a given length. If even the lowest bitrate the encoder allows would produce a bigger file than you asked for, the page says so. Raise the size limit, or cut the recording shorter with the audio trimmer first.

Where your data goes

Decoding, resampling and MP3 encoding all run in your browser, using an encoder bundled with this page. The audio you compress is never uploaded.

Checked against the tool on

Top